Screen Printed White American Flag Heat Transfers

Press Settings

Step-by-Step Application

1. Prepare Your Heat Press. Set the heat press to 320–350°F with 40 PSI / firm pressure. Use a traditional heat press. Do not use a Teflon sheet or any kind of cover.
2. Pre-Press the Garment. Position the garment and pre-press for 5 seconds to remove surface moisture and wrinkles before applying the transfer.
3. Position the Transfer. Place the transfer printed side down where you want the design. Avoid seams, zippers, and uneven surfaces unless the product is specifically designed for those areas.
4. Apply Heat & Pressure. Press for 12 seconds at 40 PSI / firm pressure. Maintain the recommended pressure for the full pressing time.
5. Peel the Carrier Hot. Peel the transfer paper immediately while hot. Do not wait for the transfer to cool.
6. Inspect the Transfer. Check that the design is fully bonded, including edges and fine details, before continuing production.

Important Precautions

• Always perform a test press before starting full production. We are not responsible for damaged garments.
• Must use a traditional heat press capable of maintaining the required temperature and even pressure.
• Do not use a Teflon sheet or any kind of cover.
• Do not apply transfers over seams, zippers, or uneven surfaces unless specifically permitted.
• Confirm that your garment material is compatible with the selected transfer and application temperature.
• Peel hot immediately. Peeling too late may affect adhesion.

Care Instructions

• Wash Cold Inside Out.
• Best if Hang Dry or No Heat if Must Tumble Dry Low Heat.
• Do Not Bleach.
• Do Not Iron Imprint/Transfer.
• Do Not Dry Clean.
• Best Not to use fabric softener.

Always perform a test press before full production to verify adhesion, application settings, and garment compatibility.